System Blue Not Working
#6
I can confirm R825 is unpopulated on my System Blue (PCB 19.3).

When you apply power, the LEDs should illuminate in this sequence (with Power always on):

1. Mode, Network, GPS (with a low beep)
2. Fault, Alarm
3. Mode, Network (if connected), Fault
4. A high beep will sound when fault turns off again.

Have a go at following the DFuSe firmware update procedure in the assembly instructions, hopefully that fixes it Smile


Attached Files Thumbnail(s)
   
Stations: 1614
Reply


Messages In This Thread
System Blue Not Working - by tferoli - 2016-09-26, 23:53
RE: System Blue Not Working - by DnH2016 - 2016-09-27, 00:14
RE: System Blue Not Working - by piepants - 2016-09-27, 02:16
RE: System Blue Not Working - by tferoli - 2016-09-27, 02:24
RE: System Blue Not Working - by piepants - 2016-09-27, 03:27
RE: System Blue Not Working - by piepants - 2016-09-27, 06:06
RE: System Blue Not Working - by Tobi - 2016-09-27, 10:21
RE: System Blue Not Working - by tferoli - 2016-09-28, 18:38
RE: System Blue Not Working - by DnH2016 - 2016-09-29, 11:30

Forum Jump:


Users browsing this thread: 2 Guest(s)