Blitzortung.org Forum - System blue problem

Hi guys I have some problem with my system blue.
In admin control panel I have this message :
You need to Save to Flash and Reboot to take effect some of the new settings!
If I click on save button and reboot, the system has the same message.
I have the 8.2 firmware.
Another problem is that the System blue often emits a long beep and the LAN LED disappears.
I have to turn it off and on again to unlock it.
Can you help me?
Thanks in advance

excuse for my bad English

(2016-11-29, 05:00)ohifra Wrote: [ -> ]You need to Save to Flash and Reboot to take effect some of the new settings!
If I click on save button and reboot, the system has the same message.

That's strange. Is this still the case? Can you reproduce it?

(2016-11-29, 05:00)ohifra Wrote: [ -> ]Another problem is that the System blue often emits a long beep and the LAN LED disappears.

Unfortunately this is currently a common issue. Try to enable "Hide Hardfaults" under System menu.

(2017-01-06, 13:37)Tobi Wrote: [ -> ]
(2016-11-29, 05:00)ohifra Wrote: [ -> ]You need to Save to Flash and Reboot to take effect some of the new settings!
If I click on save button and reboot, the system has the same message.
That's strange. Is this still the case? Can you reproduce it?

(2016-11-29, 05:00)ohifra Wrote: [ -> ]Another problem is that the System blue often emits a long beep and the LAN LED disappears.
Unfortunately this is currently a common issue. Try to enable "Hide Hardfaults" under System menu.

Good morning, I solved the problem by connecting the detector with a LAN cable category 7 and after I set the LAN port in full duplex.