2016-07-08, 10:10
(This post was last modified: 2016-07-08, 10:12 by Jorgeminator.)
Ghetto style ferrite shielding à la Cutty. Adhesive aluminum foil wrapped around a tube of printer paper. The adhesive wasn't conductive so I had to make a bridge by patching the overlapping edge with an upside down piece of foil (picture #3). I left a 2mm gap to let the magnetic field inside (picture #4). I'm not even sure if this will decrease the noise, but I thought I'd try nonetheless.
![[Image: 0MAJJTa.jpg]](http://i.imgur.com/0MAJJTa.jpg)
![[Image: bIDYxDr.jpg]](http://i.imgur.com/bIDYxDr.jpg)
![[Image: 0MAJJTa.jpg]](http://i.imgur.com/0MAJJTa.jpg)
![[Image: bIDYxDr.jpg]](http://i.imgur.com/bIDYxDr.jpg)
![[Image: wlVOvPv.jpg]](http://i.imgur.com/wlVOvPv.jpg)
![[Image: CTsEBGC.jpg]](http://i.imgur.com/CTsEBGC.jpg)
Stations: 1481