I used these pigtails for the switch.
https://www.adafruit.com/products/1003
You can also cut the 2x3 header to be a 2x2 for pins 1,2 and 3,4.
That would leave the through holes to solder wires for the switch as well.
I would only do this if you are not using the box.
You want want to be able to disconnect the switch if you need to remove the board.
https://www.adafruit.com/products/1003
You can also cut the 2x3 header to be a 2x2 for pins 1,2 and 3,4.
That would leave the through holes to solder wires for the switch as well.
I would only do this if you are not using the box.
You want want to be able to disconnect the switch if you need to remove the board.