Controller Signal Page data
#3
(2016-11-10, 00:26)allsorts Wrote:
(2016-11-09, 23:54)VA_LM_Blue Wrote: "S, L, & L P" sometimes being written just to the right of the 1A and 1B channel rows.
I have searched but have not found any information on their meaning.
Search harder, this question was answered back in July:
https://forum.blitzortung.org/showthread.php?tid=1861

 L = Signal is below the threshold
 P = Signal is below threshold * adjustable_percentage
 S = Spike detected
 M = Amplitude too high (currently not enabled)
 A = Automatic filter by amplitude

These filters are always on. If a channel is marked red, then it might not be sent. If the time stamp above the signal graphic is red, no channel signals are sent. If filters flags like "L" or "A" are present on all channels, a signal won't be sent ("AND" condition). Other's, like "S" need only one filtered channel, and no signal will be sent.


Stations: 689, 791, 1439
Reply


Messages In This Thread
Controller Signal Page data - by VA_LM_Blue - 2016-11-09, 23:54
RE: Controller Signal Page data - by allsorts - 2016-11-10, 00:26
RE: Controller Signal Page data - by cutty - 2016-11-10, 01:47

Forum Jump:


Users browsing this thread: 1 Guest(s)