too much noise
#6
I would go to manual mode, turn the gains all the way down on E channel. Then start turning them up until you start getting too much noise, then back off.

To get to manual mode, go to Settings tab.

Under Main go to Remote Control and change the drop down menu to Manual and click apply.

The go to Settings again and AMP 2.

Try gain of 1 and 1.

Slowly increase the gain as needed, 2 and 1, 4 and 1, etc... until the noise is too high.

Consider them multipliers, 1x1 is 1, 4x1 is 4, 5x2 is 10.

Then select a lower gain on first number and increase the second number.

Maybe reverse them.

Find the best combination.

For me it was 5x10, but I am also using filters that I installed.
Kevin McCormick KB0UOI
Macomb, IL USA
Stations: 1539
Reply


Messages In This Thread
too much noise - by GoSt - 2017-02-11, 12:39
RE: too much noise - by GoSt - 2017-02-11, 12:50
RE: too much noise - by cutty - 2017-02-11, 13:25
RE: too much noise - by GoSt - 2017-02-11, 15:29
RE: too much noise - by GoSt - 2017-02-11, 16:18
RE: too much noise - by kevinmcc - 2017-02-11, 19:58
RE: too much noise - by GoSt - 2017-02-13, 12:31

Forum Jump:


Users browsing this thread: 1 Guest(s)