BOM and Gerber Files?
#4
So you only need dimensions of the board, positions of the connectors and mounting holes, etc? The board is a shade under 139 x 131 mm. The connectors are along the shorter side with the LEDs opposite. There are three mounting holes, two are in the corners of the LED side 0.3" in from the board edges. Other positions are not so easy to get.
Cheers
Dave.

Stations: 1627
Reply


Messages In This Thread
BOM and Gerber Files? - by lowriderdog37 - 2017-09-02, 21:54
RE: BOM and Gerber Files? - by BobW - 2017-09-03, 01:43
RE: BOM and Gerber Files? - by lowriderdog37 - 2017-09-03, 13:56
RE: BOM and Gerber Files? - by allsorts - 2017-09-03, 21:08
RE: BOM and Gerber Files? - by Apogee - 2018-06-29, 05:51
RE: BOM and Gerber Files? - by kevinmcc - 2018-07-02, 03:19
RE: BOM and Gerber Files? - by Tobi - 2018-07-06, 11:47
RE: BOM and Gerber Files? - by lowriderdog37 - 2018-09-03, 14:18
RE: BOM and Gerber Files? - by dupreezd - 2018-09-03, 14:28
RE: BOM and Gerber Files? - by gerbold - 2018-09-03, 22:19
RE: BOM and Gerber Files? - by bostwickenator - 2019-04-06, 19:30
RE: BOM and Gerber Files? - by mwaters - 2019-04-07, 01:41
RE: BOM and Gerber Files? - by bostwickenator - 2019-04-07, 15:37
RE: BOM and Gerber Files? - by 42bios - 2021-06-01, 11:25

Forum Jump:


Users browsing this thread: 1 Guest(s)