Blitzortung.org Forum › Public Forums › Hardware, Software, Lightning Physics v
Pulling RF off the H-amp?

Linear Mode
Pulling RF off the H-amp?
RichoAnd Offline
Developer
Posts: 1,220
Threads: 77
Joined: 2012-07-01
#4
2014-08-20, 05:42 (This post was last modified: 2014-08-20, 05:50 by RichoAnd.)
I suggest right after the HP-Filter.
Lower cutoff (-3 dB point) is 3KHz, and 50/60 Hz are attenuated significantly.
A 430-470 Ohm at that point is acceptable - this gives an attenuation of 20dB at the outlet.
Remember first stage amplifier ~ 0-30dB
Will we hear about the result? Wink


Attached Files Thumbnail(s)
   
Stations: 584, 585, 2017
Website
Reply


Messages In This Thread
Pulling RF off the H-amp? - by b.e.wilson - 2014-08-20, 01:10
RE: Pulling RF off the H-amp? - by b.e.wilson - 2014-08-20, 01:41
RE: Pulling RF off the H-amp? - by RichoAnd - 2014-08-20, 05:42
RE: Pulling RF off the H-amp? - by Bonzo - 2014-08-21, 17:44
RE: Pulling RF off the H-amp? - by b.e.wilson - 2014-08-21, 17:58
RE: Pulling RF off the H-amp? - by Bonzo - 2014-08-21, 19:04
RE: Pulling RF off the H-amp? - by Einar - 2014-08-21, 20:09
RE: Pulling RF off the H-amp? - by b.e.wilson - 2014-08-22, 01:40
RE: Pulling RF off the H-amp? - by RichoAnd - 2014-08-22, 09:37

Forum Jump:


Users browsing this thread: 1 Guest(s)