SOLVED: Identifying interference with oscilloscopes and software-defined radio
#9
(2017-08-08, 19:58)pasense Wrote: You should consider to use the low pass filters. With them I could cut out the high frequency noise and could concentrate on hunting the noise sources around 10-30 kHz. Soldering the tiny filters in was far easier than I feared, but they are of course a bit expensive.

I am seriously considering buying those filters. I read in the instructions manual that they are enabled in software by soldering closed a jumper. I'm very curious what options appear in the web interface when you do this. Is it possible to adjust the frequency manually, and what are the limits??

Thanks!
Stations:
Reply


Messages In This Thread
RE: Identifying interference with oscilloscopes and software-defined radio - by djhuft - 2017-08-10, 00:21

Possibly Related Threads...
Thread Author Replies Views Last Post
  Identifying which controller I'm looking at Dale.Reid 3 6,267 2016-06-20, 14:19
Last Post: Tobi
  NeB Q: Will nearby FM Radio Cell towers cause problems br1ght 2 5,763 2015-09-18, 20:53
Last Post: br1ght
  Gain settings by software? PA4EME 4 13,933 2014-09-07, 21:14
Last Post: Andrew.Instone-Cowie



Users browsing this thread: 1 Guest(s)