2017-04-02, 12:47
Yeah looks good now.
I run my unit in Manual mode because the Auto is not very consistent when the remote server tries to control the unit. I think most people use Manual.
With that and having your gains set at 10 x 10 for amp 1, and your threshold voltage at 120mVpp, that should be a good starting point and keep you out of interference mode. If not then you can back off the gain on the amps.
I run my unit in Manual mode because the Auto is not very consistent when the remote server tries to control the unit. I think most people use Manual.
With that and having your gains set at 10 x 10 for amp 1, and your threshold voltage at 120mVpp, that should be a good starting point and keep you out of interference mode. If not then you can back off the gain on the amps.