2017-07-03, 23:30
You can also see Vin, Vref, and the GPS 1 PPS signal by selecting the relevant one and clicking Start in the "Signal Tools" box on the "Signals" page. It's advisable to turn off the Auto scalingand set the Y voltage scale to 80 - 100%.
TBH I'm not sure where the Vin is being measured. My status page has "Input Volatge" at 4.92 V but Vin on the signals page is 4.65 V.
TBH I'm not sure where the Vin is being measured. My status page has "Input Volatge" at 4.92 V but Vin on the signals page is 4.65 V.