2025-07-25, 21:19
Ooooookaaaaayyyyy.
So it seems I stumbled on the .brd and .sch files.
I guess nobody dropped by who knew the location.
The next question is, there must be some programming to be loaded onto the Atmega.
How would that happen?
If I got the boards built, will I be able to use them?
I see info about firmware for the STM32.
I was looking at a place that would make small batch boards and install the SMD components. Pricey im sure but i would really like to have the E Field. I have built a few projects like this supplied with board and SMD and I do the through hole.
So it seems I stumbled on the .brd and .sch files.
I guess nobody dropped by who knew the location.
The next question is, there must be some programming to be loaded onto the Atmega.
How would that happen?
If I got the boards built, will I be able to use them?
I see info about firmware for the STM32.
I was looking at a place that would make small batch boards and install the SMD components. Pricey im sure but i would really like to have the E Field. I have built a few projects like this supplied with board and SMD and I do the through hole.