Channel won't be transmitted!!
#8
(2015-03-14, 14:59)Tobi Wrote: The behaviour of automatic channel disabling has been disabled for now (also for other reasons). It was only activated, if there was no or wrong PCB number, regardless of interference etc...

However, if there's no valid amplifier PCB found on both inputs, then still no server will be assigned and signals won't be sent at all.

Was it with my E-field amplifier? What does it mean "wrong PCB number"?
Amplifier (PCB13, PCB14) worked properly for more than a week.
The controller detects the amplifier PCB13.1 correctly and signals can be seen in the "signals" page. There was no interference in the channel.
What should I do to the E-field amplifier can use?
Reply


Messages In This Thread
Channel won't be transmitted!! - by Gregory_J - 2015-03-13, 06:21
RE: Channel won't be transmitted!! - by cutty - 2015-03-13, 12:34
RE: Channel won't be transmitted!! - by Tobi - 2015-03-13, 12:41
RE: Channel won't be transmitted!! - by cutty - 2015-03-13, 15:17
RE: Channel won't be transmitted!! - by kriu - 2015-03-14, 14:16
RE: Channel won't be transmitted!! - by Tobi - 2015-03-14, 14:59
RE: Channel won't be transmitted!! - by kriu - 2015-03-14, 17:14

Forum Jump:


Users browsing this thread: 1 Guest(s)