Green System PCB 6 Ver 8.0. No Green Light
#1
Just tonite I had finished installing the antenna outside. I turned off the Green system board Pcb 6 ver 8.0


Now when I go to start the tracker program its starts up and then it shuts down right after 2 or 3 seconds.

I have the yellow light blinking GPS blue light  timer to GPS flashing every sec and the red light is on.

Now I dont see the green light going on it is off.  Undecided

Is there any procedure to hard reboot this board so I hope to get the default settings working again and that
the software tracker would be able to communicate to the data board. Sounds like the software is not able to
communicate.

As an update as of 1216am DST I just was able to get the green to stay on by setting the jumpers back on
for the GPS at 9600 baud now thats ok but now the software tracker loads up then shuts down a few seconds later
darn it! Confused  Dodgy Sad

Thanks  Blush  
Paul
Palm Beach Gardens Florida
Stations: 654
Reply


Messages In This Thread
Green System PCB 6 Ver 8.0. No Green Light - by Kalamara - 2015-09-10, 03:38

Possibly Related Threads…
Thread Author Replies Views Last Post
  I will buy SYSTEM GREEN!!!! meteolab 2 1,261 2024-09-30, 18:15
Last Post: meteolab
  Biogas explosion Severn Trent Green Power Cassington AD Facility kelper 4 5,058 2023-10-05, 14:20
Last Post: cutty
  System Green for FREE + postage. SalesJam 6 25,945 2020-04-18, 19:33
Last Post: SalesJam
  Two Issues so far...Fault light & Request Acct. Mike 13 57,027 2019-08-26, 05:59
Last Post: Slaviks
  GREEN stations ThomasSc 2 15,479 2018-02-19, 14:34
Last Post: Tobi

Forum Jump:


Users browsing this thread: 1 Guest(s)