System Blue Not Working
#1
Hey Everyone,

I have a System Blue (PCB 19.3).  The system does not seem to be working.  I have everything soldered up according to the instructions... When I plug it in the following happens:

- Solid Red Power Light on main PCB.
- Solid Light on both E and H field boards.
- GPS light (on PCB, not the blue LED soldered on) blinks like 7 times and just then off.

I have a grounding clamp connected to the outside of the RG6, seemed a good place to ground. 

That's all that seems to happen.  LAN is not active (no lights on router or PCB RJ45 network connector).

Is this normal? If I have bad GPS reception (this is on my work bench in basement) will the unit fail to boot?

Thoughts?

Confused
Reply


Messages In This Thread
System Blue Not Working - by tferoli - 2016-09-26, 23:53
RE: System Blue Not Working - by DnH2016 - 2016-09-27, 00:14
RE: System Blue Not Working - by piepants - 2016-09-27, 02:16
RE: System Blue Not Working - by tferoli - 2016-09-27, 02:24
RE: System Blue Not Working - by piepants - 2016-09-27, 03:27
RE: System Blue Not Working - by piepants - 2016-09-27, 06:06
RE: System Blue Not Working - by Tobi - 2016-09-27, 10:21
RE: System Blue Not Working - by tferoli - 2016-09-28, 18:38
RE: System Blue Not Working - by DnH2016 - 2016-09-29, 11:30

Forum Jump:


Users browsing this thread: 1 Guest(s)