SOLVED: Identifying interference with oscilloscopes and software-defined radio
(2017-08-08, 19:58)pasense Wrote: You should consider to use the low pass filters. With them I could cut out the high frequency noise and could concentrate on hunting the noise sources around 10-30 kHz. Soldering the tiny filters in was far easier than I feared, but they are of course a bit expensive.

Hi pasense. I don't want to hijack this magnific thread, but I have doubts about soldering the low pass filters (I already have them). Any link or post where to see the PCB place and soldering tips?

Thanks !!
Luis.   (Lugo, Spain)
Stations: 1831

Messages In This Thread
RE: Identifying interference with oscilloscopes and software-defined radio - by Breitling - 2017-08-09, 07:14

Possibly Related Threads…
Thread Author Replies Views Last Post
  Possibility of contributing to a second-tier experimenta hardware / software effort? louloulou 0 4,265 2020-08-16, 19:04
Last Post: louloulou
  Identifying which controller I'm looking at Dale.Reid 3 19,176 2016-06-20, 14:19
Last Post: Tobi
  NeB Q: Will nearby FM Radio Cell towers cause problems br1ght 2 16,043 2015-09-18, 20:53
Last Post: br1ght
  Gain settings by software? PA4EME 4 30,338 2014-09-07, 21:14
Last Post: Andrew.Instone-Cowie

Forum Jump:

Users browsing this thread: 1 Guest(s)