Housing for System Blue (laser cut/3d print)
#2
At first, I just hung my controller from whatever was handy along the wall of my basement. Later, I copied what Cutty (Mike, one of the moderators here) did and used a clear polycarbonate anti-static hard drive shipping box. Photo at http://www.w0btu.com/files/misc/Lightnin...1977photos.

But it sounds like you can do much better that I did!

EDIT: Where are you located?
Regards,
Mike W.
Stations: 1977, 2294
Reply


Messages In This Thread
RE: Housing for System Blue (laser cut/3d print) - by mwaters - 2018-01-08, 01:26

Forum Jump:


Users browsing this thread: 4 Guest(s)