Housing for System Blue (laser cut/3d print)
The newer main boards have the ethernet chip moved away from the VLF front end to over by the buzzer. The GPS module sits between the ethernet connector and the VLF front end. This means the GPS antenna connector and ethernet connector have swapped places. I think something has happened down near the USB power input as well but that *might* not involve any connector movements.

The compendium has PNG's of, at least the earlier, PCB design and layout with grid, so you can get positions can be optained from that. Which might be better than physically measuring a PCB.

Stations: 1627

Messages In This Thread
RE: Housing for System Blue (laser cut/3d print) - by allsorts - 2018-02-08, 23:04

Forum Jump:

Users browsing this thread: 4 Guest(s)