Blue e-field antenna question
#2
(2021-07-05, 18:40)llowrey Wrote: Hello,

The documentation for the Blue kit indicates that one can use the 'built-in' antenna and includes a photo of the PCB with the rectangular section opposite the antenna screw terminal, and labeled 'Probe / Antenna' below, still attached. That rectangular section is not electrically connected to the e-field board.



It's been 25+ years since my coursework in electromagnetics so I'm a bit ignorant at this point. Is that separate rectangular section coupled in some way even though it is not electrically connected?

What, exactly, is the 'built-in' antenna?

Is it preferred to use a wire instead of the 'built-in' antenna?
llowrey, the top part is electrically connected to the bottom part, however in the past there where some that was not.
To be certain that yours are, measure it using a DVM set to Ohms.
The best however, is to use a 100mm, 14 gauge solid copper electric wire. Connect it to the inner screw connector.

Remember to update your BO profile using Input 3. Inputs 0 - 2 is used for the H field.
[Image: NOAARADlogoTXT80.png]


Stations: 2100, 2954
Reply


Messages In This Thread
Blue e-field antenna question - by llowrey - 2021-07-05, 18:40
RE: Blue e-field antenna question - by dupreezd - 2021-07-05, 18:58

Possibly Related Threads…
Thread Author Replies Views Last Post
  My E-field antenna setup TomVal 3 12,285 2020-11-05, 15:48
Last Post: cutty
  blue ferrite / loop antenna connection? MTO-Mareuil 1 6,929 2020-10-20, 11:43
Last Post: cutty
  GPS antenna SYSTEM BLUE ! IK1TTD 9 47,690 2020-06-03, 12:16
Last Post: GJ7DNI
  Can E-field antenna be casted in resin? OH4GRM 3 12,449 2020-06-01, 13:19
Last Post: dupreezd
  Blue System: PreAmp & Antenna Questions BassJohn 5 26,490 2018-02-28, 08:41
Last Post: BassJohn

Forum Jump:


Users browsing this thread: 1 Guest(s)