Fault mode after big electrostatic discharges.
#2
It looks like you are in Auto mode and going into interference mode. On the Settings tab under Remote Control, set you controller to Manual. Then under Amp 1 set all channels  to 10*10 and a threshold of 100mV and see what it looks like then.

Also disconnect the H amplifier to isolate noise coming from there. You might have noise/interference  from another damaged device or power supply.
[Image: NOAARADlogoTXT80.png]


Stations: 2100, 2954
Reply


Messages In This Thread
RE: Fault mode after big electrostatic discharges. - by dupreezd - 2024-01-30, 22:55

Possibly Related Threads…
Thread Author Replies Views Last Post
  fault led at first boot uvash 3 11,138 2021-11-18, 10:37
Last Post: aloha20
  How to get alerts of fault or missing GPS jchonig 2 7,938 2020-12-30, 18:23
Last Post: cutty
  Fault LED indicates fault j82 10 55,822 2016-09-20, 08:40
Last Post: Tobi

Forum Jump:


Users browsing this thread: 1 Guest(s)