Report: Oscillating server settings
Two days ago I noticed there was a lot of beeping from the controller. It seems that the settings for the controller/amplifier were oscillating between:
State 1: high gain/low threshold = very sensitive; gain was typically above 4000
State 2: low gain/high threshold = very insensitive
The controller would send 300+ samples a second to the server, go into Interference 1 or Interference 2 mode, then switch state and "go deaf" for a while, before reverting to the first state. I ended up going manual to stabilize it. Station 1155.
Stations: 1155

Messages In This Thread
Report: Oscillating server settings - by b.e.wilson - 2014-09-11, 14:23

Forum Jump:

Users browsing this thread: 1 Guest(s)