New station confusion
Just switched my new station on over the weekend. The ID is 1238. Status from the controller says "Normal", both amps (E + H) show noise levels and gain jumping around (automatic mode). However, the signals page shows nothing. All channels are checked "Display" but no traces appear. Do I need to do something to enable that?

The amplifier status for all input channels shows the trigger as disabled. Is that bad?

Also, on the controller's status page, in the section for remote configuration, my station ID (1238) is shown as a link but that link goes to a nearby station, not mine

Thanks for any help!
Stations: 1238

Messages In This Thread
New station confusion - by sparkyeric - 2014-11-10, 07:29
RE: New station confusion - by W3DRM - 2014-11-11, 16:03
RE: New station confusion - by W3DRM - 2014-11-12, 05:22

Forum Jump:

Users browsing this thread: 1 Guest(s)