Station 1888 near Bear Creek NC Online
#1
Greetings and I'm pleased to have a station 19.3 online and reporting data. It's still in setup and testing while I try to learn the behaviour of the system and the local noise.  I have 2 of 3 ferrites (stock models) attached in horizontal planar at 90 degrees (A & C with B disabled). On each of the ferrites one of the leads has a loop knot suggesting a polarity so I am wiring all the ferrites with respect to that polarity.  The E field channel is using the probe PCB antenna and is disabled due to large signal pulse every second. I suspect the local electric fence charger is responsible for that noise. I have installed the board into the aluminum case and have not wired up the external switch so power is applied with plug. The LEDs show some testing on power up and after about a minute or two the GPS LED begins to flash and signal LED with audio clicks can be heard. 

Plans : I will attach the third ferrite perpendicular to the planar to form a box xyz corner or Y configuration. I plan to remote this box and antennas about 1000 feet from the setup location and need to have a very stable system.

About me : I retired from hard drive R&D a couple of years ago where I designed testing methods for asperities on the disk surface. One of the problem areas is ESD so there are some sensors that attempt to measure voltage and H fields but the E field signal is small and H field signals are huge so seeing these signals from distant lightning strikes brings back those struggles.  I also built much of my test equipment and develop software (MATLAB) and python to make measurements. Now I am back  to NC where  I grew up and still want to measure stuff with Raspberry Pi and this blitzortung blue is interesting tool for LF noise analysis.

Issues : I do have a problem that I have searched for and either my search keys or the subject hasn't been discussed.  After I have made changes to the preamp settings (Normal/Disable/Don't send) the system will startup and run for about 5 minutes and then the buzzer goes on solid for a couple of seconds and the system http page freezes. The power, mode, network and fault LEDs are steady but GPS, alarm, and signal are off and the system seems to be locked up. Since it's in a case, the push button switches are not accessible so reset is done with power cable cycle.   After reset with power, the system operates for hours doesn't show any error messages on the debug screen.  I do see the local control changing the gains and some remote messages about overall gain of 6400 and thresholds of 100. Any suggestions from others experience would be helpful.
Reply


Messages In This Thread
Station 1888 near Bear Creek NC Online - by Nekota - 2017-07-03, 12:16

Possibly Related Threads…
Thread Author Replies Views Last Post
  Station 1745 is online Mike6158 14 71,111 2017-04-02, 15:45
Last Post: Mike6158

Forum Jump:


Users browsing this thread: 1 Guest(s)