Blitzortung.org Forum › Public Forums › General Discussion v
Printing 3D casing for Blue-Basic

Threaded Mode
Printing 3D casing for Blue-Basic
Kellogs Offline
Registered forum member
Posts: 26
Threads: 10
Joined: 2017-05-12
#1
2025-03-19, 17:48 (This post was last modified: 2025-03-26, 17:06 by Kellogs.)
Hello,

First I would like to thank the community for working on Blitzortung.

I am willing to buy a Blue-Basic board with pre-amp.
Are there any 3D casing plans to pring the enclosure ?

Kind regards,
Kellogs
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  How to order system blue-basic? Kellogs 3 1,346 2025-04-20, 00:09
Last Post: DrFX
  System Blue Basic - Indicator Panel for Enclosure? DrFX 0 553 2025-04-19, 23:28
Last Post: DrFX
  Does the System Blue Basic take the same Firmware as System Blue? DrFX 3 731 2025-04-19, 23:25
Last Post: DrFX
  Metal Housing for System Blue Basic DrFX 0 644 2025-03-08, 03:53
Last Post: DrFX
  Another lightning article, 3D mapping at Washington, D.C., USA Dale.Reid 0 5,677 2020-11-15, 12:56
Last Post: Dale.Reid

Forum Jump:


Users browsing this thread: 1 Guest(s)