Pulling RF off the H-amp?
#1
I've ordered a kit, and I've put together the loops. After testing them, I think I'd like to use them in my shack, which means I need to find a place on the board to pull the RF out. I was thinking directly after the first gain stage, before the signal gets to the filters. Is there an accepted method of doing this? I'm hesitant to pull the signal off the board directly into a coax to the shack, and thinking I'd better use a buffer amp. It'd be nice if a tried and tested method was out there, rather than reinvent a method.
Reply


Messages In This Thread
Pulling RF off the H-amp? - by b.e.wilson - 2014-08-20, 01:10
RE: Pulling RF off the H-amp? - by b.e.wilson - 2014-08-20, 01:41
RE: Pulling RF off the H-amp? - by RichoAnd - 2014-08-20, 05:42
RE: Pulling RF off the H-amp? - by Bonzo - 2014-08-21, 17:44
RE: Pulling RF off the H-amp? - by b.e.wilson - 2014-08-21, 17:58
RE: Pulling RF off the H-amp? - by Bonzo - 2014-08-21, 19:04
RE: Pulling RF off the H-amp? - by Einar - 2014-08-21, 20:09
RE: Pulling RF off the H-amp? - by b.e.wilson - 2014-08-22, 01:40
RE: Pulling RF off the H-amp? - by RichoAnd - 2014-08-22, 09:37

Forum Jump:


Users browsing this thread: 2 Guest(s)