How to PoE Red Controller

[chubros]

Hello to everyone. I m trying to find a way to power the red controller with a poe solution. Is there any solution? Thanks in advance.

[DelandeC]

I think the best way is to use a PoE injector like http://www.tp-link.com/lk/products/detai...TL-POE150S on one side of the cable then use a splitter like http://www.tp-link.com/en/products/detai...OE10R.html on the other side.

[chubros]

Thanks for your reply.
But in the controller side what connector may i use.? Only the ethernet? It is enough? Or i will need adapters from classic jack to micro usb?

[DelandeC]

It is not possible to power the controller directly through the Ethernet jack. (see §4.4.1 of the documentation)

So, on controller side, you'll need a PoE splitter with a Cat cable for LAN and, of course, a power cable (jack to mini-USB).

You can use your switch as injector if it is compatible with IEEE 802.3af.

[chubros]

Is there any ready (jack to mini-USB) adapter or should i make one on my own???

[cutty]

From experience, for System Red your best bet for all three of your stations would be to stay with what is recommended... a 'dedicated' low noise supply to each controller.
and avoid any possible 'loops' or ground problems, as it were. For What this is worth...

[chubros]

From experience, for System Red your best bet for all three of your stations would be to stay with what is recommended... a 'dedicated' low noise supply to each controller.
and avoid any possible 'loops' or ground problems, as it were. For What this is worth...

Thanks for your replies... I was trying to find a low noise place but there is no power there. So i was searching for a poe solution.
About the "low noise" adapter do you have any suggestions?

[cutty]

See https://forum.blitzortung.org/showthread....ight=power