Filter orientation - BLUE
#1
Assembly instructions refer to a "point" on the Pin 1 corner of the filter chips.  I see no discernible point.

Perhaps it is a terminology or translation issue.

What is a fool-proof way of making sure the filters are oriented to the board properly prior to soldering?

Is the picture in the instructions correct? Is the printing on the chips consistent?  Can the printing be used as a key to orientation?

Thanks in advance...  I want to get the filters and SMA connectors filled in, so I can get the box on the air!!!
Stations: 1961
Reply


Messages In This Thread
Filter orientation - BLUE - by KY5G - 2017-08-14, 01:25
RE: Filter orientation - BLUE - by BobW - 2017-08-14, 02:43
RE: Filter orientation - BLUE - by KY5G - 2017-08-14, 05:03

Possibly Related Threads…
Thread Author Replies Views Last Post
  System Blue - Digital Filter Pin 1 Identification rwhalb@verizon.net 28 153,257 2016-09-21, 13:34
Last Post: kevinmcc

Forum Jump:


Users browsing this thread: 1 Guest(s)