Problem after updating firmware. blue 8.32b
#6
(2017-09-05, 14:33)readbueno Wrote: After doing some tests with a multimeter. It appears C430 is now a short circuit and L403 is now open circuit, R405, the closest path to ground still reads 82 ohms?
My test equipment, little experience with failures in SMD parts and lack of replacements for these components doesn't permit me to come to any further conclusions at present.
Something has caused C430 to fail and it appears that L403 has acted as a fuse?
I will try to get replacements as quickly as possible and hope that not too much else is damaged.
Obviously, without L403 there is no power to the amplifier for the E antenna. Therefore no signals!
Any suggestions gratefully accepted.

Brian.

Brian,

I was just studying the schematic. Here are a couple of thoughts.

If the coax between the two boards was shorted, that would blow L403.
Same thing if the E-field board was shorted.
As for C430, perhaps a HV spike from the E-field board?
Regards,
Mike W.
Stations: 1977, 2294
Reply


Messages In This Thread
RE: Problem after updating firmware. blue 8.32b - by mwaters - 2017-09-06, 21:39

Possibly Related Threads…
Thread Author Replies Views Last Post
  Firmware 10 on System Red PCB 10.5 - firmware bug ??? mmlightning 0 1,162 2024-06-24, 16:47
Last Post: mmlightning
  System Blue GPS problem Steve- 12 58,971 2016-11-15, 09:35
Last Post: DnH2016

Forum Jump:


Users browsing this thread: 1 Guest(s)