what is the best setup for BO??
#10
there is something strange here...
My channel 1B suddenly sparked with a noise floor of 400+ mVpp
When i set threshold to 555 it stopped and calmed down again.. so now its @ 61-23mVpp

I unplugged my Alarm, still i got the high Noise. so i took donw H-Field for "service"....

*edit* Now im running only E-Field.
(here is the trouble about reading around, because E-Field shall be AMP2, but I have also read that if you use one antenna, it should ALWAYS be amp1) -still for test/faultdebug it should not be a problem..
I have tried E-Field @ both amps, to see if i get the noise on Amp1, but none of the amps gives the noise when using E-Field. (still i might have been "lucky" to try while the noise was not present.
and about 10 hours later, there has been no spikes on my E-Field.
http://www.lightningmaps.org/blitzortung...o_sid=1145
I started with low threshold and my E-Field was ticking away in sync (with a few sec delay) with signals on the eastern side of USA..


If im making a crude test Antenna, Coax loop is the easiest one, but if im not using transformer, should i not add a resistor? what value? (or am i remembering wrong now? )
Stations: 1145
Reply


Messages In This Thread
RE: what is the best setup for BO?? - by frode dahl - 2015-06-25, 17:10

Possibly Related Threads…
Thread Author Replies Views Last Post
  Looking to setup a new station near Barcelone VLorz 5 31,777 2016-04-02, 09:57
Last Post: VLorz
  Looking to setup station in South Africa rogerpaulthompson 45 231,394 2016-03-01, 13:43
Last Post: rogerpaulthompson

Forum Jump:


Users browsing this thread: 2 Guest(s)