error... No Amplifier connected
#1
Hi for some weeks I have a problem with the red board
I see a error  No Amplifier connected
I have test this with 2 antennas and also with 2 amp boards
All with 2 different  ferrite antenna  
1 on the roof  and for this moment 1 into this room
The firmware version I have is now 8.0  
But also with the 7.4 version I have the same problem
Ware can I look for fix this problem ?
Greetings  Gert

[Image: no_amp.jpg]
Stations: 127, 1845
Reply
#2
Does the LEDs on the amp turn on?
Clément
Stations: 733, 1440, 2601
Reply
#3
(2016-09-04, 20:08)DelandeC Wrote: Does the LEDs on the amp turn on?

Only the Red led is on  if I see the error  No Amplifier connected
Green and Yellow are off

now the amp is turning on by him self ?  and I see blinking the  4 Yellow led  and also the Green led is now on and also the Red
its very strange but the amp is turning off and on by him self
Stations: 127, 1845
Reply
#4
Did you try a other cable?
Clément
Stations: 733, 1440, 2601
Reply
#5
(2016-09-05, 04:56)DelandeC Wrote: Did you try a other cable?

Yes  I  have
Stations: 127, 1845
Reply
#6
Now I see into the screen from the board  a new error
I see now  into the SYS option   Vin Too low !
don't know if this normal ?
Stations: 127, 1845
Reply
#7
(2016-09-05, 17:55)Rothuize Wrote: Now I see into the screen from the board  a new error
I see now  into the SYS option   Vin Too low !
don't know if this normal ?

No this is not normal, it is telling you that your power supply is faulty or underpowered.
Try a different power supply that can supply 5 to 5.3V at a minimum of 2A.
Ben.
RED Station: 878,   Flightradar24: F-EGLF1,  Open Glider Network: Aldersht2, PlanePlotter: M7.
Stations: 878
Reply
#8
(2016-09-05, 18:46)Benedict.Smith Wrote:
(2016-09-05, 17:55)Rothuize Wrote: Now I see into the screen from the board  a new error
I see now  into the SYS option   Vin Too low !
don't know if this normal ?

No this is not normal, it is telling you that your power supply is faulty or underpowered.
Try a different power supply that can supply 5 to 5.3V at a minimum of 2A.
Ben.

Thanks Ben  
Only I do not have a extra power supply for this moment
for now I have it into the USB from the computer .. and I know this will not by a good idea,,  but its for this moment working  4.9V
I do have a power supply for the iphone but I think this will by also not a good idea
I will look tomorrow for a power supply

maybe this is also the problem with the Amplifier  to low power  and the Amplifier turns off ??
for this moment I run the board with 2 Amplifiers  2x ferrite antennas  now I hope all will by work ok again
thanks for this info

greetings  Gert
Stations: 127, 1845
Reply
#9
Try the PS for your iPhone
Maybe you have meassured 4,9 with a voltmeter, but it don't tell you how noisy it is Smile

/Richo
Stations: 584, 585, 2017
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)